MicDIYers - Parts List

PARTS LIST

1.   Mic Capsules - Panasonic WM-60AT (or WM-61A a little better)

      Digi-Key P/N- P9967-ND (for 60AT) P/N- P9925-ND (for 61A)


2. Yageo - Metal Film Resistors 10K Ohm 1/4 watt 1% tolerance

      Digi-Key P/N- 10.0KXBK-ND

3. Panasonic - Metallized Polyprophelyne Capacitors 2.2uf +/-5% tolerance

      Digi-Key P/N- PF2225-ND

4. Stereo 1/8" mini-plugs /or/ Mini XLR plugs. (male)

      Radio Shack or the like.

5. Panel Mount Stereo 1/8" mini jacks /or/ Mini XLR jacks. (female)

      Radio Shack or the like.

6. 4 ft of 2 conductor shielded cable. small diameter. 22 > 24 awg. Or a recycled pair of in-ear headphones.

      Radio Shack or the like.

7. Battery Box - Small project box.

      Radio Shack Cat.# for a binaural pair is 270-1801

8. Project PCBoard for inside battbox. Will probably need to be cut down to fit in battbox.

      Radio Shack or the like.

9. 9v Battery holder or snap connector.

      Radio Shack snap connector Cat. # 270 - 324 (comes in packs of 5)

10. Assorted small gauge wire 20awg or smaller. For connecting components in the battbox.

      Radio Shack or hanging around the garage.

11. Black Papermate Pen (this will be the body of the mic) Can also use 1/4" diameter brass

      tubing, or even an empty .22 bullet shell.

12. Mini alligator clips (optional) Can also use a small piece of velcro.

      Digi-Key P/N- CP-2406 (this P/N includes the rubber boot, not necessary. Ask for the non booted)

13. Epoxy, hot glue or the equivalent

14. Shrink tubing, 3M FP-301. (important!) Stay away from the shinny stuff at Radio Shack.

15. PATIENCE!!!

Good Luck!

non-commercial use and must retain the copyright notice.

Site Copyright© 1998 MicDIYers